Flushing is required any time valve cleaning has been performed. Follow these steps:
Step 1: Connect stove to Fuel Bottle with DragonFly Pump as if assembling for operation. (Do not include windscreen or Heat Reflector).
Step 2: Remove Flame Spreader, Jet and Shaker Jet Needle.
Step 3: Turn On/ Off Valve and Flame Adjuster ON and allow fuel to run through fuel line for 30 seconds. CAUTION: Always flush away from any ignition source. Spilled fuel is a fire hazard! Light stove away from cleaning area and only after residual fuel on stove has evaporated.
Step 4: Reinstall Shaker Jet Needle, Jet and Flame Spreader.
Step 5: Light stove. While stove is lit, adjust output several times through full range of flame. This may loosen remaining deposits.
If clogging persists, repeat flushing process. Two or three flushing cycles are often required to completely clean out deposits.
To watch a YouTube video on DragonFly Stove Maintenance, click here.